Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Irvine, CA
Chimney repair in Irvine usually comes down to one of three things: a rusted factory-built gas fireplace that hasn’t been touched since the house was framed, a missing or HOA-mismatched chimney cap, or flashing that’s given up after 30 years of Santa Ana wind cycles. Most Irvine homes were built after 1970, so the problems we see most are not creosote-choked masonry flues. They’re aging prefabricated units, deteriorated chase tops, and venting systems that were never inspected after the builder walked away. Firebrick Chimney Sweep has served Irvine since 2012, and if it involves the chimney, the flue, or the venting above it, we handle it. Call (866) 520-4943 for a straight answer and a free estimate.
Why Irvine Homes Are Different
Irvine is a master-planned city, and that changes what we actually find on rooftops and inside fireplaces. Most of the housing stock was built from the 1970s onward in tracts like Woodbridge, Westpark, and the Portola Springs area. That means prefabricated, factory-built fireplaces dominate, not traditional masonry chimneys. The fireplaces in these homes are often zero-clearance units with metal flues and a wooden or stucco chase built around them, and those systems age differently than a brick chimney.
Because Irvine’s climate is mild and Mediterranean, fireplaces get used only a few weeks a year, mostly December through February. Creosote buildup is slow, so sweeping demand is genuinely low and seasonal. The bigger issue is neglect. A gas fireplace that runs two weeks a year might go 15 years without an inspection. We regularly find decorative gas logs that were later converted to wood burning without a proper liner upgrade. That’s a hidden fire hazard, and it’s a distinctly Irvine pattern. In the older pockets near Culver Drive and throughout the 92604 ZIP, original wood-burning fireplaces built in the 1970s are more common, and those need sweeping more often.
HOA covenants are another Irvine reality. Many communities require chimney caps that match a specific profile or finish, and a homeowner who installs the wrong cap can get a letter within a week. We’ve done enough Irvine jobs to ask the right question up front: is your HOA going to care what this looks like from the street?
Styles & brands we work with
Our Main Irvine Services
Most Irvine homeowners call us for one of two jobs: a chimney sweep or a dryer vent cleaning. Both are about clearing restricted ventilation before it becomes something worse.
Chimney Sweep in Irvine
In Irvine, a chimney sweep is less about heavy creosote removal and more about a thorough inspection of a system that’s been mostly idle. For gas fireplaces, we remove the logs, inspect the burners and pilot assembly, vacuum the firebox, and check the flue from the top down. For wood-burning fireplaces in older homes, we remove creosote, check the damper, and look for cracks in the firebox and flue. The seasonal nature of fireplace use in Irvine means late fall is when most people call. Chimney Sweep in Irvine covers what we do in detail.
Dryer Vent Cleaning in Irvine
Dryer vents clog with lint in Irvine homes the same way they do everywhere, but townhome and condo layouts often mean longer vent runs with more bends, which trap more lint. We clean the full vent run from the dryer to the exterior termination, clear blockages, and check that the termination flap opens and closes correctly. Lint buildup is one of the leading causes of residential fires, and a blocked vent also makes your dryer work harder and take longer. Dryer Vent Cleaning in Irvine explains the process and what we look for.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Irvine
When a chimney in Irvine needs repair, it’s usually a Chimney Repair that traces back to the home’s age and construction style. A 1980s tract home with a factory-built fireplace might have a rusted chase top or a corroded cap that’s letting rain into the chase. A 1970s ranch in the 92604 ZIP might have original flashing that’s pulled away from the roofline after decades of sun and wind. The repairs are different, but the starting point is always the same: we get on the roof, open the system up, and tell you exactly what needs fixing, with photos you can see for yourself.
Chimney Cap Installation
Signs you need it
You don’t have a cap at all, or a rusted cap is sitting loose on the flue.
What it costs in Irvine
Expect to pay roughly $180 to $350 for a standard cap and installation in Irvine.
How we do it
We measure the flue or chase opening, set the cap with mechanical fasteners, and confirm the mesh sizing keeps birds and embers out without restricting draft.
Chimney Cap Replacement
Signs you need it
Your existing cap is rusted through, the mesh is torn, or the cap no longer fits securely after a storm.
What it costs in Irvine
Replacement typically runs $150 to $300, depending on the cap size and whether the flue tile needs minor prep first.
How we do it
We remove the old cap, clean the flue crown surface, and install a correctly sized replacement, usually a Copperfield or Gelco cap from our stock.
Chimney Liner Installation
Signs you need it
Your clay tile liner is cracked or spalling, or a wood-burning fireplace was added to a system never designed for that heat.
What it costs in Irvine
A new liner installation in Irvine usually falls between $1,200 and $3,500, with the spread driven by flue height and diameter.
How we do it
We run a camera inspection to confirm the flue dimensions, then install an appropriately sized liner, typically a DuraFlex system, and reconnect the appliance at the base.
Chimney Flashing Repair
Signs you need it
You see water staining on the ceiling near the fireplace, or the metal flashing around the chimney is lifting or cracked.
What it costs in Irvine
Flashing repair in Irvine typically costs $200 to $500, depending on how much of the existing flashing can be reused.
How we do it
We inspect the roof-to-chimney transition, remove compromised flashing sections, and install new step or counter flashing sealed to the roofline.
Chimney Crown Repair
Signs you need it
The concrete crown is cracked, spalling, or pooling water instead of shedding it.
What it costs in Irvine
Plan on $300 to $700 for a crown repair in Irvine, more if the crown needs a full rebuild.
How we do it
We clean the crown surface, fill or resurface cracks with an appropriate cementitious compound, and restore slope so water drains away from the flue.
What Chimney Repair Costs in Irvine
| Item | Typical range in Irvine |
|---|---|
| Chimney cap installation | $180 – $350 |
| Chimney cap replacement | $150 – $300 |
| Chimney liner installation | $1,200 – $3,500 |
| Chimney flashing repair | $200 – $500 |
| Chimney crown repair | $300 – $700 |
Irvine prices do push toward the upper end of these ranges when a roof is steep, a chase is tall, or an HOA requires a specific cap finish. The quote we give you before we start is the price you pay. We don’t open a repair with an open-ended estimate.
Does chimney repair in Irvine require an HOA approval?
Often, yes. Many Irvine homeowners associations require design review for anything visible from the street, which includes chimney caps and chase tops. We’ll tell you what to submit and can usually provide the spec sheet for the cap we’re installing, so the HOA has exactly what it needs.
Can you repair a prefabricated gas fireplace chimney in Irvine?
Yes, and that’s most of our Irvine repair work. Factory-built fireplaces have specific clearance and component requirements, so we don’t retrofit random parts onto them. We install components matched to the unit, and when the original manufacturer is out of business, we source through our professional supply network.
Brands We Service in Irvine
We work with professional-grade chimney components, not whatever’s stocked at the hardware store. That means DuraFlex liners, HeatShield ceramic resurfacing for deteriorating flues, and Gelco, Olympia Chimney, and Famco caps and dampers. We keep common Irvine sizes in stock, which means a standard cap replacement often goes from diagnosis to done in a single visit. Our brands reflect how we approach every job: fix it with the right part, not the cheapest one.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Irvine, CA
| Service | Typical range in Irvine |
|---|---|
| Chimney cap installation | $180 – $350 |
| Chimney cap replacement | $150 – $300 |
| Chimney liner installation | $1,200 – $3,500 |
| Chimney flashing repair | $200 – $500 |
| Chimney crown repair | $300 – $700 |
What pushes price up in Irvine is access: two-story chases, steep tile roofs, or HOA-mandated cap finishes that require a custom order. What doesn’t push price up is scope creep after we arrive. We quote the job in writing before we start, and the number doesn’t change unless you add work to the list.
Neighborhoods We Serve in Irvine
We’re on Irvine roofs from the 92603 and 92604 pockets near Culver Drive up through 92617, 92618, 92619, and 92620. Most appointments in Irvine are scheduled two to five days out, with the fall rush pushing that into the one-week range in November.
- Woodbridge
- Westpark
- Portola Springs
- Woodbury
- University Park
Service Area – Cities Near Irvine
Firebrick Chimney Sweep also works throughout the surrounding communities, including Tustin, CA, Aliso Viejo, CA, Santa Ana, CA, and North Tustin, CA. The housing patterns and chimney types shift a bit as you move across those borders, but the approach stays the same: inspect first, explain what’s actually wrong, and fix it with professional-grade materials.
Serving Irvine, CA — Our Local Coverage Area
We’re based in the Irvine area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Irvine
Most Irvine appointments are scheduled within two to five business days. During the late fall and early winter rush, that can stretch to a week. If you have an active leak or a visible chimney issue, tell us when you call and we’ll work to fit you in sooner.
If the work is visible from the street, there’s a good chance the answer is yes. Caps, chase tops, and any exterior chimney components usually fall under HOA design review in Irvine’s planned communities. We can supply spec sheets and product details to support your application.
Yes. Most Irvine homes we service have prefabricated gas fireplaces or gas log sets, but we also inspect, sweep, and repair the original wood-burning fireplaces found in older neighborhoods near Culver Drive and in the 92604 ZIP. The inspection process is tailored to whichever system you have.
Firebrick Chimney Sweep has served Irvine since 2012. Chimney repair, sweeping, and dryer vent work are what we do, and we do them with the parts a trade professional would choose, not whatever’s on the shelf at the big-box store. Call (866) 520-4943 for a free estimate, or to schedule an inspection. If something’s wrong with your chimney system, you’ll know exactly what it is and what it costs to fix before you spend a dollar.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Irvine Customers Say
"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
— Lucia Ramirez"Something came loose about a month after the work. Called them, and they were back out the next day and fixed it at no charge. Didn't argue, didn't try to bill me for the trip."
— Ebony Bryant"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
— David Wong