Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Sun City
Dryer vent cleaning in Sun City typically runs $129 – $189 for a single-story home with an accessible exterior hood, and most jobs are completed within 90 minutes. We work throughout 92586, 92585, and 92587 weekly, so scheduling doesn’t mean waiting a week for someone to show up. Call (866) 520-4943 and we’ll give you a straight answer on cost before we ever step through the door.
Here’s what actually matters in Sun City: most homes were built between 1961 and the mid-1970s, and a lot of them still have the original vinyl flex duct running from the dryer to the wall. That duct crushes, kinks, and collects lint differently than the rigid metal we install today. Knowing what’s behind a Del Webb stucco wall before we cut into it is the difference between a 45-minute cleaning and a half-day repair. We’ve worked enough of these ranches off Sun City Boulevard, McCall, and Ridgemoor to know exactly what we’re opening up.
Why Firebrick Chimney Sweep Is Sun City’s Preferred Dryer Vent Cleaning Company
Most dryer vent companies in Riverside County treat the dryer as an isolated appliance. We don’t. Firebrick works on chimneys every single day, and dryer vents and chimneys share the same core risk: restricted, dirty ventilation that becomes a fire. When we clean a dryer vent in a Sun City ranch, we’re also checking the exhaust path the way a ventilation specialist would, not just shoving a brush through a tube.
We repair what we find. A crushed vinyl flex run behind a 1972 Maytag in a Del Webb original isn’t a referral to some other contractor. We replace it with rigid metal, seal the joints, and install a new hood if the old one is rusted shut. Same visit. One company, no referrals.
Nelson Quijada built Firebrick around a simple idea: chimney work is all we do, and that depth shows in every inspection. We carry HeatShield, Gelco, and Olympia Chimney materials because these are the products professionals spec. Not whatever’s stocked at the hardware store. When you call about a dryer vent in Sun City, you’re getting a company that thinks in terms of flues, exhaust pathways, and combustion risk, not a guy with a shop vac and a brush.
Do your own research before booking. Ask any company whether they’ll show you camera footage of the inside of your vent before and after. We do that on every single job, and we walk you through it on your own phone so you have the record.
Styles & brands we work with





Our Dryer Vent Cleaning Services in Sun City
Dryer Vent Cleaning
A standard Sun City ranch with a short exterior wall run takes us about 60 to 90 minutes. We disconnect the dryer, run a rotating brush and vacuum the full length of the duct, clean the exterior hood, and run a camera through the line afterward so you can see the result. If the run goes through the attic chase next to the fireplace stack (common in 92586 originals), it adds time because we’re working overhead and checking for crushed sections. The camera shows us what the brush can’t reach.

Dryer Vent Repair & Replacement
In Sun City, we regularly see original vinyl flex duct crushed behind the dryer or eaten through by rodents in the attic. We pull it, replace it with smooth rigid metal, and re-route the run if needed. On Del Webb homes where the dryer vent shares a wall chase with the fireplace flue, we inspect both while we’re in there. You get the vent fixed and a clear picture of what’s happening behind the wall.

Dryer Vent Hood Replacement
Santa Ana winds drive grit and dust into exterior hoods on low-pitch stucco walls all over Sun City. The flap seizes, then the vent terminates inside the wall cavity instead of outdoors. We replace the hood with a new dampered unit, seal the wall penetration, and confirm airflow at the exterior with a smoke test. In 92585 and 92587, where homes sit closer to open dirt and horse properties, we see this faster than anywhere else in the Menifee area.

Dryer Vent Inspection & Camera Scope
If you’ve inherited a Del Webb home or you’re buying one, get the dryer vent scoped before closing. We’ve pulled bird nests, wasp nests, and decades of packed lint out of vents that looked fine from the outside. A camera scope is part of every cleaning we do in Sun City, and it’s also available as a standalone inspection if you’re not ready for a full cleaning yet. You see exactly what we see.

What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Sun City
When a Sun City home needs a liner, a vent component, or a fireplace repair, we don’t run to a big-box store. We work with HeatShield, Gelco, and Olympia Chimney because these are professional-grade suppliers used by certified chimney and ventilation specialists. HeatShield ceramic resurfacing, for example, lets us restore a deteriorating flue liner without a full relining. That’s an option most sweep-only operators in Sun City can’t offer. The same logic applies to dryer vents: we use rigid metal, proper clamps, and dampered hoods designed for the job, not whatever flex kit is on sale in Perris. If a part needs to be ordered for your specific home, we let you know the timeline before you commit.
Common Dryer Vent Cleaning Problems We See in Sun City Homes
- Original vinyl flex runs in Del Webb homes (92586). The flex duct installed in the 1960s and 70s crushes behind the dryer and kinks at the wall connection. Lint packs into those folds and restricts airflow until the whole run becomes a fire load. We replace it with rigid metal on the spot.
- Seized exterior hoods on low-pitch stucco walls. Grit and dust driven by Santa Ana winds jam the damper flap shut. The dryer keeps pushing hot, lint-filled air into the wall cavity because it has nowhere else to go. A new hood with a check for proper clearance fixes it.
- Attic chase runs adjacent to the fireplace stack. In Sun City’s original single-story ranches, the dryer vent often runs through the same attic chase as the fireplace flue. Nobody looks up there for decades, and what starts as a dryer vent problem becomes a shared ventilation problem.
- Nests in long-vacant or inherited homes. A house that sat empty on the market or after an estate transfer in Sun City is a magnet for birds and wasps. The exterior hood looks fine from the ground, but the run is blocked with nesting material and the first load of laundry pushes heat back into the laundry room.
See the difference
Before
After
Before
After
Before
AfterPricing for Dryer Vent Cleaning in Sun City, CA
A typical dryer vent cleaning in Sun City runs $129 – $189 depending on the length of the run and whether it’s a wall, floor, or attic-chase exit. If the run goes through the attic chase next to the fireplace stack in a Del Webb original, expect the higher end because we’re working overhead and scoping a longer path. Replacing crushed vinyl flex with rigid metal adds $75 – $150 in materials and labor, and a new exterior hood runs $45 – $85 installed. We give you a flat price before starting, and we show you the camera footage that justifies any recommendation. Nothing gets recommended without evidence you can see. Call (866) 520-4943 for an exact quote on your home, and we’ll tell you what you’re looking at before we schedule.
We Also Serve Cities Near Sun City
Firebrick works throughout the Menifee Valley and the surrounding Inland Empire communities. When you call about Dryer Vent Cleaning in Sun City, we also book jobs in Quail Valley, Romoland, Good Hope, and Perris, often routing multiple stops on the same day through the 215 corridor. The same team, the same camera scope on every job, and the same straight answer on pricing in every city. If you’re on the Sun City side of that map, you’re in our regular service area, not an occasional stop.
Serving Sun City, CA — Our Local Coverage Area
We’re based in the Sun City area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Sun City
Because in Del Webb homes built in the 1960s and 70s, the dryer vent often shares the same wall chase or attic run as the fireplace stack, and both have been collecting lint and dust grit for 50-plus years. When we’re already scoping the chimney, checking the adjacent dryer run takes minutes and often turns up a restriction the homeowner didn’t know existed. The two systems have the same failure mode: restricted, dirty ventilation that becomes a fire. Call (866) 520-4943 and we’ll scope both while we’re at your home.
Yes. White vinyl flex duct does not meet current code for a reason: it crushes easily, kinks at the wall connection, and holds lint in the spiral folds. In a Sun City home where that duct has been in place since the Nixon administration, it’s almost certainly restricted. We replace it with smooth rigid metal, which carries lint out of the house instead of letting it settle. We’ll show you the before photo so you can see the difference.
Stand outside while the dryer runs and look at the hood. If the flap isn’t moving and there’s no warm air exiting, it’s seized. On Sun City’s low-pitch stucco walls, Santa Ana winds pack grit into the flap hinge and it rusts in place. The dryer then exhausts into the wall cavity, which is a slow-motion lint fire and a mold problem. We replace the hood and test with a smoke pencil, so you can see the airflow with your own eyes.
Start with the dryer vent and the chimney, in that order. Vacant Sun City homes attract birds and wasps into exterior hoods and flues, and a house that sat through two or three Inland Empire summers has had plenty of time for lint and grit to settle. We scope the dryer run, check the hood, inspect the chimney flue, and hand you a photo report of everything we found. The cost of that inspection is a fraction of what a duct fire or a backed-up dryer costs to clean up.
No. Nothing gets recommended without footage you can see on your own device. If the camera shows a clear run with minor lint, we clean it and tell you it’s fine. If it shows crushed flex, a rusted hood, a nest, or a separated joint, we’ll show you that before we quote a repair. If a previous company told you the vent needed thousands of dollars of work without showing you why, get a second look from a company that documents everything.
Call Firebrick Chimney Sweep for Dryer Vent Cleaning in Sun City
If you’re in Sun City, Quail Valley, Romoland, Good Hope, or Perris and the dryer hasn’t been cleaned in years (or you don’t know when it last was), call (866) 520-4943. We’ll give you a flat price before we book, we’ll show you the camera footage on the day of the job, and we’ll tell you plainly if the vent can wait or if it needs attention now. This is what we do every day, and in a town full of 50-year-old ranch homes, doing it right means seeing everything before we touch it.
Written by Nelson Quijada, Owner at Firebrick Chimney Sweep, serving Sun City and the surrounding Menifee Valley.