Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Upland
Dryer vent cleaning in Upland typically runs $129 – $249 for a standard single-story ranch home, and we can usually get to your property within a few days of your call. The homes across Upland’s 91786 core, many built in the 1950s through 1970s, often still have their original foil flex duct, and that’s where we find the worst problems. If your dryer takes two cycles to finish a load, or the laundry room smells like hot lint when the machine runs, call Firebrick Chimney Sweep at (866) 520-4943 – we’ll give you an honest assessment and a free estimate.
Why Firebrick Chimney Sweep Is Upland’s Preferred Dryer Vent Cleaning Company
We’re a chimney and ventilation company first. That matters in Upland, because the same structural discipline we bring to chimney flues and liners carries directly into how we approach dryer exhaust runs. A dryer vent is a ventilation system, not just a tube. We inspect it that way.
Our techs know Upland’s housing stock. The flat core of 91786 is full of single-story ranch homes from the postwar decades, many with original laundry rooms tucked against exterior walls on the north side of the house. The vent runs are usually short but poorly built: foil flex crushed behind the dryer, plastic transition collars that have gone brittle with heat, louvered hoods that no longer close. The foothill properties in 91784 are different: newer construction, often longer runs through interior walls, sometimes with gas dryers and tighter clearances. We approach each one accordingly.
We also carry real repair capability, not just a brush. When we find a crushed section of flex duct or a rusted wall hood, we replace it with rigid Dryer Vent Cleaning-grade components, not whatever the hardware store has. Nelson Quijada built Firebrick around full-service ventilation, and that’s what Upland homeowners get.
Styles & brands we work with





Our Dryer Vent Cleaning Services in Upland
Full Dryer Vent Sweep and Inspection
We run the full length of the vent with a rotating brush and collect the lint at the exterior hood. Most Upland ranch homes have vent runs of 10 to 20 feet, so the job usually takes under an hour. We photograph everything, including the interior of the duct, so you can see the before and after. If the run is longer or has multiple bends, we’ll say so before we start and adjust the plan.

Lint Blockage Removal and Airflow Restoration
In Upland’s dry climate, lint accumulates faster than you’d expect. Low humidity and Santa Ana winds dry the lint out, and the dry air in the duct means it stays light and fibrous, ready to ignite at lower temperatures. We clear full blockages and measure airflow at the hood with a vane anemometer, so you know the number before we leave, not just that it feels better.

Foil Flex Duct Replacement in Older Upland Ranches
The 1950s-to-1970s homes across 91786 often still have original foil or vinyl flex duct. It crushes behind the appliance, traps lint in the accordion folds, and is nearly impossible to clean properly. We replace it with rigid smooth-wall duct, which is what current code calls for anyway. Most of these runs are short enough that replacement costs about $90 – $160 in parts on top of the sweep.

Wall Hood and Exterior Flap Repair
The plastic and galvanized hoods on Upland homes take a beating from the summer sun. Flaps warp, hinges rust, and the gaps let birds in, particularly in the foothill-adjacent streets of 91784, where the mountain bird population is active all year. We replace failed hoods with new louvered units and seal the penetration properly.

What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Upland
We work with professional-grade components from HeatShield, Gelco, and Olympia Chimney. Dryer vents don’t need the same ceramic resurfacing products we use on chimney flues, but the standards are the same. We specify rigid duct, proper transition fittings, and louvered hoods built for years of exposure, not a season. If you’ve had a home inspector flag a dryer vent, or an insurance carrier ask for documentation, we’ll provide clear photos and a written summary of the work.
Common Dryer Vent Cleaning Problems We See in Upland Homes
- Original foil flex duct in 1960s ranch homes. We find it crushed behind the dryer and packed with six or more years of lint in homes across the 91786 core. The duct folds snag lint on every rib, and nobody ever sees it because it’s hidden behind the appliance.
- Summer heat failure on wall hoods and transition collars. Upland’s hot dry summers bake plastic components until they crack and warp. The exterior flap stops closing, and then the mountain breeze pushes debris in, and the run becomes a birdhouse.
- Long, un-swept runs in single-story homes. Even a 15-foot run with a couple of sharp elbows can hold enough dry lint to be a serious fire hazard. Because Upland’s low humidity keeps the lint dry, it stays combustible all year, not just during the Santa Ana season.
- Dryer taking two cycles to finish a load. This is almost always a vent restriction. The thermostat cycles off early because the heat can’t escape, so the drying time stretches. Upland homeowners often tell us they assumed the machine was just old. It isn’t. The vent is plugged.
We saw this pattern on a 1962 single-story ranch off Mountain Avenue in 91786. The original foil flex duct was crushed behind the dryer and packed with six years of lint, and the exterior wall hood had rusted open, letting mountain-area birds nest in the run. We pulled the old flex, swept and cleared the full run, and replaced it with rigid smooth-wall duct and a new louvered hood. The homeowner called back the next week to say the drying time dropped by nearly half.
See the difference
Before
After
Before
After
Before
AfterPricing for Dryer Vent Cleaning in Upland, CA
A standard dryer vent cleaning in Upland runs $129 – $189 for a single-story home with a vent run under 20 feet and easy exterior access. Two-story homes or longer runs typically come in at $189 – $249. If we need to replace foil flex with rigid duct, add $90 – $160 in materials. Exterior wall hood replacement adds about $45 – $90 depending on the hood and whether we need to re-seal the penetration.
Some Upland homes were built with the laundry room in the center of the house, which means a longer run and a more involved cleaning. We price that honestly after we see the floor plan and access points. Every quote we give in Upland is a flat price agreed before we start – no hourly billing, no add-on surprises. Call (866) 520-4943 for a free estimate.
We Also Serve Cities Near Upland
Our team covers Upland and the surrounding foothill communities. That includes San Antonio Heights, Claremont, Montclair, and Rancho Cucamonga. If you’re just over the city line, give us a call, we’ll usually be there within a few days.
Serving Upland, CA — Our Local Coverage Area
We’re based in the Upland area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Upland
Yes, and that’s the difference. We inspect the entire vent run structurally, the same way we inspect a chimney flue. That means checking the transition behind the dryer, the duct condition along its full length, the exterior hood, and the airflow at the exit. A dryer vent is a combustion gas exhaust system in the broad sense; we treat it with the same care. Call (866) 520-4943 to schedule.
In Upland, the failure pattern is heat-driven, not cold-driven. The hot, dry summer weather bakes the plastic components on your dryer’s vent-hood and transition collar. They crack and warp, then the first Santa Ana winds push debris into the run and clog it. Coastal cities see more winter corrosion; Upland sees late-summer heat failure followed by a clogged vent in early fall.
Every 12 months, and more often if your dryer still has foil flex duct. Homes built in the 1950s through 1970s across 91786 frequently have vent runs that were never updated, so lint builds faster. If we replace the flex with rigid smooth-wall duct, you can usually extend the interval to 18 – 24 months.
The exterior wall hood and the foil flex duct. In Upland’s older 91786 homes, the hood is usually an original galvanized or plastic unit that has been weathering for decades. The flap rusts or warps, the opening stays exposed, and then the mountain birds move in. The flex duct fails because it’s crushed behind the dryer, trapping lint in the folds. We address both in a single appointment.
In most Upland homes we visit, yes. A dryer that takes two cycles means the moist, lint-laden air isn’t escaping. The heating element cycles off early on the high-limit thermostat, and the clothes never fully dry. We start with a vent inspection and airflow test, and if the vent is the restriction, we clear it and prove the airflow before we leave. Call (866) 520-4943 for a free estimate.
Contact Firebrick Chimney Sweep for Dryer Vent Cleaning in Upland
If your dryer vent hasn’t been cleaned in a year or more, or you’re seeing longer dry times, or the exterior hood doesn’t close anymore, give us a call. We’ll inspect the full run, show you exactly what we find with photos, and give you a flat price before any work starts. Reach us at (866) 520-4943 for a free estimate anywhere in Upland, including 91784, 91785, and 91786.
Written by Nelson Quijada, Owner at Firebrick Chimney Sweep, serving Upland and the Inland Empire.